Sign Craft: Make A Rustic “Cheers” Sign
Greet your guests with a cheery welcome with this sign that you can make using birch branches, wine corks and a little bit of paint in fun colors. This craft would also be fun to make and hang for a special party.
The word “cheers” conjures up happy thoughts and colorful images to me so I wanted to make sure and use plenty of color for this craft. However, since I was still going for a rustic style, I wanted to give it a distressed and somewhat dirty look. I will show you just how I did that with a couple of easy techniques.
Here is everything that you will need along with the all of the instructions:
- 6 inch x 12 inch piece of birch or other plywood (mine was 1/8 inch thick)
- birch or other branches
- wine corks
- sharp knife and cutting board
- four colors of acrylic paint
- paint brushes
- Weathered Wood crackle medium
- gloss varnish
- walnut stain
- tacky glue
- thick gauge floral wire
2. Paint the entire front of the board with your base color of paint. This is the color that will show through when the top layers of paint crackle and peel. I used “pure gold” for this layer. Your pencil marks should still show through.
4. Apply your first color of paint to the first third of the board. As you start brushing on the paint, you will notice that the paint starts to peel away in spots. This is what you want. The Weathered Wood medium gives that second layer a nicely distressed look. Clean your brush and add your next color of paint and finish with your third choice.
5. After all of the paint was dry, I wanted to dirty it up a little bit. To make the paint look even more distressed, I went over the whole thing with walnut stain. The second picture shows stain on most of the yellow and a little on the orange and a very little on the green. The colors didn’t show up so great in these pictures but hopefully you get the idea.
6. I applied gloss varnish over the top when the stain was dry to protect the finish.
7. Using a pruning shears, I cut up some thin birch branches to form my letters and glued them in place with tacky glue.
8. I used a sharp knife to slice a wine cork into thin slices to use as an embellishment. For a “Cheers” sign, I figured I should have some “bubbly” and thought it appropriate to use a wine cork to make little bubble embellishments. I glued these in random spots on my letters with tacky glue.
9. Finally, I drilled two holes at the top of my sign to insert a section of floral wire through for hanging. I simply twisted each end around itself a few times to secure the wire in place.
Here are a few close up pictures of the sign to give you a little better picture of the craft:
This project has been shared at the following sites: